Configuring The Installation - Ecolab Dryexxeco Advanced-Eth Betriebsanleitung

Software description
ð The PIN for the appropriate user level is set.
5. Repeat the operation for all user levels.
8.3.3

Configuring the installation

The 'Setup' menu is used to assign the metering stations/valves to the installations and
set the parameters of the signal exchange.
Starting point: Screen 'System settings'
N o F a u l t !
time
setup
signals
Software: V6.3
Fig. 17: System settings
1. Press [setup].
Setup:
Selection
ð The 'Setup: Selection' screen opens.
The following selection can be made:
n [setup dosing units/valves]
n [setup communication]
The following information and settings can be made or accessed:
- Back to the 'start screen.'
[Return] - Return to the 'System Settings screen'
on page 56
Rev. 03-12.2023
Password edit
Light: + Light: -
start up
Return
Hardware: V1.0
N o F a u l t !
setup dosing units/valves
setup communication
Return
Ä Chapter 8.1 'Start screen' on page 52
Ä Chapter 8.3 'System settings'
60