Scheppach DECO-XL Original Bedienungsanleitung Seite 26

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts,
• Application other than specified,
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE0113 not being observed.
Please consider:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
The operating manual is intended to help the user to
become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations.
The operating instructions include important instruc-
tions for the safe, proper and economic operation of
the machine, for avoiding danger, for minimising repair
costs and downtimes and for increasing the reliability
and extending the service life of the machine.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the machine in your country.
Keep the operating manual package with the machine
at all times and store it in a plastic cover to protect it
from dirt and moisture. They must be read and careful-
ly observed by all operating personnel before starting
the work.
The machine may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
26 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (fig. 1-21)
1. Blow-off hose
2. Connection point A (blow-off device)
3. Star grip screw
4. Holder (saw blade guard)
5. Saw blade guard
6. Saw table
7. Foot pedal
8. Cover, left
9. Batteries
10. Bearings
11. Tightening lever
12. Arm
13. Graduated scale
14. Star grip screw
15. Extraction connection
16. On/off switch
17. Operating mode selection switch
18. Speed regulator
19. Assembly points
20. Work lamp
21. ON / OFF switch work lamp
22. Saw blade
23. Allen key 2.5 mm
24. Retaining device
25. Screw (depressor)
26. Table inlay
27. Saw blade holder, top
28. Assembly device
29. Saw blade holder for saw blades without pins
30. Saw blade holder, bottom
31. Angle
32. Screw (graduated scale)
33. Pointer
34. Screw (left cover - front)
35. Screw (left cover - rear)
36. Allen key 3 mm
37. Connection point B (blow-off device)
38. Phillips screws (battery compartment)
39. Warning light
www.scheppach.com