Troubleshooting - VOLTCRAFT Energy Logger 4000 Bedienungsanleitung

17. Troubleshooting

In purchasing the Energy Logger 4000, you have acquired a product which has been designed to the state of
the art and is operationally reliable.
Nevertheless, problems or faults may occur. For this reason, the following is a description of how you can
eliminate possible malfunctions yourself.
Please always observe the safety instructions!
Error
Data transmission to SDHC
card does not start
No operation possible.
No data memor any more
available (MEM < 2%).
Repairs other than those just described should only be performed by an authorised specialist.
Our technical support is happy to answer any questions you might have about using the measurement
device.
34
Possible cause
The card symbol is not in the display.
The card symbol is flashing. The card
is full or does not correspond with the
requirements (size, format).
You are mode „Data transmission".
The internal data memory is full.
Remedy
Insert the card until end of the card
slot.
Loosen the card or replace it.
After the end of the data tranmissions
remove the SDHC card from the
measurement device.
Back up the data on a SDHC card
and delete the data memory.