Troubleshooting; Technical Data - VOLTCRAFT R-200 Bedienungsanleitung

Troubleshooting

In purchasing the DMM, you have acquired a product which has been designed to the state of the
art and is operationally reliable.
Nevertheless, problems or faults may occur.
For this reason, the following is a description of how you can eliminate possible malfunctions
yourself.
Please observe the safety instructions!
Error
The multimeter
doesn't function
No measured value
change.
Repairs other than those described should only be carried out by an authorised spe-
cialist. If you have queries about handling the measuring device, our technical sup-
port is available under the following telephone number:
Voltcraft®, 92242 Hirschau, Lindenweg 15, Tel.-No. 0180 / 586 582 7.

Technical Data

Display
Measuring rate
Measuring lead length
Measuring impedance
Automatic Power-Off
Voltage supply
Working conditions
Operating altitude
Storage temperature
Earth DMM
Dimensions (LxWxH)
Over-voltage category
Possible cause
Is the battery dead?
Is the wrong measurement function
active (AC/DC)?
Did you use the wrong measuring
sockets?
Is the fuse for the current ranges or
the low Ohm range defect?
Is the Hold function activated
(display "HOLD")
LCD, 4000 Counts (digits) with bargraph
approx. 2 measuring operations/second
approx. 80 cm each
>10MΩ (V range)
approx. 30 minutes
6 x mignon batteries (AA)
0 - 40°C (<80%rF)
max. 2,000 m
-10°C to +60°C (<70%rF)
approx. 550 g
200 x 92 x 50 (mm)
CAT III 600 V, Impurity level 2
Remedy
Check the battery status. Battery
replacement
Check the display (AC/DC)
measurement value change and switch
the function if necessary.
Check the measuring socket setting.
Check the fuses.
Press the "HOLD" button to
deactivate this function.
41