2A Intended Use - NovoPress HA5 Betriebsanleitung

2.3 Press ring DN 65:
Dimensions:
Weight:
2.4 Press ring DN 80:
Dimensions:
Weight:
2.5 Press ring DN 100:
Dimensions:
Weight:
2.6 Case for the press rings:
Dimensions:
Weight:
2.7 Transport car:
Dimensions:
Weight:

2A Intended use

The HCP system electrohydraulic press tool is intended exclusively for use with the Pressfitting
System MAPRESS SUPER-SIZE DN 65, DN 80 and DN 100.
Any other or further use will be regarded as improper use. Novopress will not be liable for any
damage resulting from improper use. The sole responsibility will be held by the user. Intended
use also includes following the operating instructions and complying with the inspection and
maintenance requirements.
The press tool may only be used after the operator has received an appropriate introduction.
External diameter:
Width:
External diameter:
Width:
External diameter:
Width:
Width:
Length:
Depth:
Height:
Height when folded:
Width:
Depth:
Depth when folded:
3
approx. 190 mm
approx. 70 mm
approx. 6 kg
approx. 200 mm
approx. 70 mm
approx. 6.6 kg
approx. 225 mm
approx. 70 mm
approx. 8 kg
approx. 490 mm
approx. 544 mm
approx. 137 mm
approx. 11 kg
approx. 1180 mm
approx. 810 mm
approx. 620 mm
approx. 625 mm
approx. 635 mm
approx. 34 kg