Technical Specifications; Intended Purpose; How It Works - NovoPress ECO 301 Betriebsanleitung

ENGLISH
GB
Read instruction manual carefully.
Observe the enclosed safety warnings.
1.

Technical specifications

Connection: Cable (l=5m) with plug
Motor:
Supply voltage:
Power consumption:
Max. speed:
Operating mode:
Class:
Maximum force:
Height: approx. 110 mm / width: approx. 85 mm / length: approx. 420 mm / weight: approx. 4.7 kg
2.

Intended purpose

The press tool is only suitable for use with Novopress press jaws and intermediate jaws. These press
jaws/intermediate jaws are normally offered by the system suppliers.
The tool and press jaws are only intended for pressing pipes and fittings for which the particular press jaws
are designed.
Any other use above or beyond the scope described above shall be deemed as improper use. Novopress
shall not be liable for resultant damage. Risk shall be borne solely by the user. Proper usage shall also
include following the instruction manual and observing inspection and servicing conditions.
The press tool must only be operated after the user has received instruction.
3. Brief description of press tool
(1) = Start button
(2) = Stop button
(3) = red
(4) = green
4.

How it works

The press tool operates electromechanically.
Signal tone
After the pressing has been carried out correctly a signal tone sounds once. In the event of faults, or if
pressing was not carried out correctly, the signal tone will sound 6 times (see Point 10).
Retaining pin guard
The electronic safety system checks whether retaining pin (10) has been pushed in all the way. The
machine cannot be put into operation if retaining pin (10) has not been pushed in correctly.
see type plate
560 W
30000 rpm
S9
see type plate
45 kN
Start 2s = Press the Start button for 2 seconds to switch
on the automatic press facility.
1 x OK = Pressing carried out correctly.
6 x OK = Incorrect pressing or tool fault.
= to deactivate a pressing process, e.g. in hazardous
situations
the press tool
LED
LED = mains ON (LED lit)
or to cancel a fault indicator and re-start
9
see brief
description of LED