NovoPress HA5 Betriebsanleitung Seite 39

5.6. Allow the pawls Z of the hydraulic cylinder to clamp into the press ring grooves (see illustration
to point 5.5).
5.7. When positioning the hydraulic cylinder for the pressing process, it is important to leave
sufficient distance (X>20 mm; Y>40 mm) between it and any fixed parts or walls because the
hydraulic cylinder executes a minimum movement in the X and Y directions during the pressing.
5.8 Both press ring pins A should clamp correctly into the pawls Z of the hydraulic cylinder.
Otherwise, the pressing process will not begin when the switch lever E is activated (as a safety
precaution).
The sides of the hydraulic cylinder and the press ring shown in bold print must be positioned
parallel to one another.
Incorrect
Z
Correct
A
Z
7
≠
=