Waeco AirCon Service ASC 6300 G LE Bedienungsanleitung Seite 32

EN
• Container for UV additive (11)
• Drained oil receptacle (12)
5. When the scales are relieved, press
will flash. Once you have set the zero point, the selection menu for the scales appears again.
6. Return the containers to the operating positions: Reattach the containers for oil (10) and (12) and for the UV
additive (11) to the snap locks and close the cover (13).
7. Press STOP
14.5 Changing the dryer filter
1. In the basic menu use the cursor keys or to select Free selection.
Short selection
Free selection
Other selections
ENTER‐OK
2. Press ENTER
3. Skip the query requesting CAR DATA.
4. Select Rec/Recycling phase.
5. Set the Pressure increase Test time to
6. Press ENTER
7. Deselect Vacuum phase using
8. Press ENTER
9. Deselect Filling phase using
10. Press ENTER
11. Select Process start.
12. Press ENTER
The service hoses will now be drained and the A/C service unit's basic menu will be activated. The compressor
has produced a slight internal vacuum so that the filter can be replaced with minimal refrigerant loss.
13. Switch off the A/C service unit.
14. Pull out the power supply plug.
15.
CAUTION! Health hazard
The following steps may only be performed by authorized personnel. Wear protective gloves and gog­
gles.
Unscrew the screw (D) from the holder, and pull the dryer filter straight out.
16. Replace the O­rings (E). Moisten new O­rings with refrigerant oil before installing.
32
ENTER
twice to access the standby menu.
to confirm.
to confirm.
.
No
to confirm.
.
No
to confirm.
to confirm.
to confirm. The prompt to remove the containers from the scale
.
1