EN
Use the cursor keys or to select the line of company data you want.
6. Use the keypad and the cursor keys to enter the data. To switch between upper and lower case, press the
key. To delete a character, briefly press the
key.
7. Press
ENTER
8. Press
STOP
The set data is activated.
9. Press
STOP
The standby menu is displayed.
12.7 Entering the date and time
Date and time are required for logging of the service procedures. The date and the time are printed along with the
company data on every service log.
1. In the basic menu use the cursor keys or to select Other selections.
Short selection
Free selection
Other selections
ENTER‐OK
2. Press
ENTER
3. Use the cursor key to select Service.
4. Press
ENTER
5. Enter the password
6. Use the keypad and the cursor keys to enter the information.
7. Press
ENTER
8. Press
STOP
The standby menu is displayed.
12.8 Editing default values
The A/C service unit has preset values for the most important service tasks. The default values appear
automatically when you select the respective menu.
You can alter the following default values if necessary:
Parameter
Pressure increase test time min.
Vacuum time min.
Leak test min.
PAG oil ml. (additional quantity)
14
to confirm.
.
again.
to confirm.
to confirm.
.
8463
to confirm.
.
C
key. To delete the current line, press and hold down the
Default value
1
1
4
0
C