Silvercrest SLE 200 B2 Bedienungsanleitung Seite 11

Always place the appliance on a solid, flat surface so
■
that it cannot tip over.
Do not permanently install the appliance. Position the
■
appliance so that its side panels have a clearance of
at least 20 cm from walls or other objects and ensure
a clearance of at least 30 cm from the front, rear and
top panels of the appliance in order to ensure good air
circulation. Take care not to obstruct the air inlet and
outlet opening.
The appliance may only be operated in rooms with an
■
ambient temperature of 5°C to 32°C.
Use the appliance only in rooms up to 16 m².
■
The appliance must be installed, operated and stored in
■
a room with a floor area greater than 4 m
If the appliance is operated in unventilated areas, these
■
must be designed in such a way that the refrigerant
cannot accumulate anywhere in the event of refrigerant
leakage. Otherwise, a combustible mixture may be
formed.
The appliance may only be stored in rooms without
■
permanent sources of ignition (e.g. open flames, a
switched-on gas appliance or an electric heater).
The appliance must be stored in a way that does not
■
damage it.
Clean the air filter before it becomes heavily soiled.
■
While draining via a hose, ensure that it does not
■
become blocked and that the open end of the hose is
positioned at a lower level than the outlet aperture. The
end of the hose must be positioned above a drain.
■ 8 │ GB │ IE
2 .
SLE 200 B2