3M Speedglas G5-01 Gebrauchsanweisung Seite 14

AIR CONTROL
The air distribution inside the welding helmet can be adjusted to suit your
personal preference. The air control lever on the left side, fig. 12a, will
adjust the airflow direction, either from above (over the forehead), below
(over the jaw area) or both. The direction of the air coming from the upper
air outlet is adjustable towards your face or towards the visor using the
right side air control, fig. 12b. When all the air is coming from the lower air
outlet the right side air control lever is disabled. The air comfort is also
affected by the welding helmet's distance to the face, fig. 3.
DETACHMENT OF OUTER SHIELD
For longer periods of grinding or other non-welding tasks, the outer shield
can be detached from the inner visor, fig. 13a - 13b.
CLEANING INSTRUCTIONS
Clean the welding helmet with a mild detergent and water
^ To avoid damage to the product do not use solvents or alcohol for
cleaning or disinfection. Clean the headcover according to the washing
instruction on the product label.
MAINTENANCE
• visor plate, fig. 6a-6d
• welding filter fig. 7a-7f
• headband fig. 8
• sweatband fig. 9
• headcover fig. 10
• face seal fig. 11a-11c
• neck cover fig. 14a-14c
• comfort pad for headband fig. 5b
^ Worn out product parts should be disposed of according to local
regulations.
STORAGE AND TRANSPORTATION
When stored as stated in technical specification, the expected shelf life of
the product is five years. The original packaging is suitable for transporting
and storage.
TECHNICAL SPECIFICATION
Weight welding helmet
(excl. headband and welding filter): 665g
Weight headband:
Viewing area visor plate:
Expected service life:
Head sizes:
Material:
Helmet:
Silver front frame:
Visor plate:
Headband:
125g
104 x 170mm
non-condensing conditions.
non-condensing conditions.
non-condensing conditions.
5 years depending on conditions of
use
50-64 cm
PPA
PPA
PC
PA, PP, TPE, PE
13