Mains Connection; Personal Protection And Protection Of Others; Noise Emission Values; Danger From Toxic Gases And Vapours - Fronius Transpocket 3500 Remote Bedienungsanleitung

Before leaving the workplace, ensure that people or property cannot come to any
harm in your absence.
Mains connec- Devices with a higher rating may affect the energy quality of the mains due to
tion their current consumption.
This may affect a number device types in terms of:
-
-
-
*)
at the interface with the public grid
see "Technical data"
In this case, the plant operator or the person using the device should check whe-
ther the device may be connected, where appropriate by discussing the matter
with the power supply company.
IMPORTANT! Ensure that the mains connection is earthed properly
Personal protec-
Keep persons, especially children, away from the device and working area during
tion and protec- operation. However, if persons are in the vicinity:
tion of others -
-
Before leaving the working area, ensure that no personal injury or property da-
mage can occur in your absence.
Noise emission The device generates a maximum sound power level of <80 dB(A) (ref. 1pW)
values when idling and in the cooling phase following operation at the maximum permis-
sible operating point under maximum rated load conditions according to EN
60974-1.
It is not possible to provide a workplace-related emission value during welding
(or cutting) as this is influenced by both the process and the environment. All
manner of different welding parameters come into play, including the welding
process (MIG/MAG, TIG welding), the type of power selected (DC or AC), the
power range, the type of weld metal, the resonance characteristics of the work-
piece, the workplace environment, etc.
Danger from to- The fumes produced during welding contain harmful gases and vapours.
xic gases and va-
Welding fumes contain substances that cause cancer, as stated in Monograph
pours
118 of the International Agency for Research on Cancer.
Use at-source extraction and a room extraction system.
If necessary, use a welding torch with an integrated extraction device.
Keep your face away from welding fumes and gases.
Fumes and hazardous gases
-
-
Connection restrictions
Criteria with regard to the maximum permissible mains impedance
Criteria with regard to the minimum short-circuit power requirement
Inform them of any dangers (hazardous acids and gases, risk due to grid and
charging current, etc.),
Provide suitable protective equipment.
must not be breathed in
must be extracted from the working area using appropriate methods.
*)
*)
47