Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Check before use!
• Check the safe condition of the device:
• Check the device for leaks.
• Check the device for visual defects.
• Check that all parts of the device have been securely fitted.
• Check that all safety devices are in proper condition.
Start Fig. 17, 19-23
Once the machine has been set up properly, start the engine as follow:
1. Turn the engine switch to the ON position. Fig. 20
2. Put the choke lever on the
3. Press the fuel pump more than 5 times. Fig. 19
4. Pull the recoil starter handle (9) 3-5 times to start the engine. Fig. 21
Never place feet on the shaft or kneel on it.
5. Once the motor is running, briefly wait, then put the choke lever into position.
6. To start the cutting tools, operate the release lever (8) with the palm of your hand, and the throttle
lever (11) with your fingers. The further you push the throttle lever, the higher the motor speed.
When releasing the throttle lever, the motor becomes idle and the cutting tools stop. Fig. 23. The
cutting tools should not continue turning and should not move when the motor is idle.
7. If there are problems, immediately turn the motor switch (7) to "0" so the motor stops. Caution:
The cutting tools may continue turning for a few seconds. Fig. 23
8. If any problem occurs, pull the pin of safety belt, then release the brush cutter immediately. Fig. 17
9. If the motor is warm, you can leave the choke lever in the "warm start and work" position.
Note: If the engine does not start up even after several attempts, read the section „Engine trouble-
shooting".
Note: Always pull the starter cord out in a straight line. If it is pulled out at an angle, then friction will
occur on the eyelet. As a result of this friction, the cable will become frayed and will wear away fast-
er. Always hold the starter handle when the cable retracts.
Never allow the cable to snap back when it has been pulled out.
Note: Do not start the motor in tall grass.
m Attention: When the engine has been switched off, the cutting unit continues running for several
seconds therefore do not touch the cutting unit until it has come to a standstill!
9. Working instructions
Working with brush cutter / grass trimmer
• When you work with the petrol brush cutter for the first time, familiarize yourself with the operation
and control of the petrol cutting blade without running engine.
• The design of the petrol brush cutter allows for operation only at the right side of the user's body.
• Keep the petrol brush cutter firmly with both hands on the handles.
• Always make sure that the cutting tool continues to rotate briefly after the throttle has been re-
leased.
• Always so that the cutting tool no longer turns in a proper engine idle not press down the throttle.
• Always work with high speed so you have the best cutting results.
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
position. Fig. 20
Fig. 22
GB | 51
Werbung
