Scheppach P-MGB4-1 Anleitung Seite 45

• Never use your hands to stop the cutting device.
• Always wait until it stops on its own.
• Hold and guide the trimmer head as close to the ground as possible.
• Only cut grass growing on the ground. Do not cut grass in cracks in walls, growing or on rocks, etc.
• Always make sure no objects, or other debris is collecting in the trimmer head, in the protective
hood, or in the engine.
• Only use the tool, when the guard is attached.
• Always switch off the tool, before you put it down.
• Keep in mind that there is risk of injuries in the area of the cutting device intended to cut off the line.
• CAUTION: The cutting tool continues rotating for a few seconds after the engine is turned off.
• Put the tool down only after the cutting tool has completely stopped and the motor is turned off.
• When the cutting tool is damaged, it must be replaced at once.
• Always use the original line only. Never use a metal wire instead of the nylon line.
• Tool and cutting tools must be properly inspected and serviced periodically. Damages must be
repaired by a service center.
• Only use accessories recommended by the manufacturer.
• Have your tool serviced only by qualified personnel and by use of original spare parts only. This
ensures that the tool will work safely in the future.
Residual risks
• There will always be residual risks, even if you use this equipment according to instructions. The
following hazards can occur in connection with the construction and design of this tool.
• Health hazards resulting from swinging of hand and arm if the equipment is used for an extend-
ed period and if it is not operated or maintained properly.
• Injuries and material damage caused by ejection of tool attachments which are unexpectedly
thrown from the equipment because of sudden damage, wear and tear or improper attachment.
• Warning! This tool generates an electromagnetic field during operation. Under certain circum-
stances, this field can affect active or passive medical implants. In order to reduce the risk of se-
vere or fatal injuries, we recommend that people with medical implants consult their doctor and
the manufacturer of the medical implant before operating the machine.
• Use the gripping spikes for every cut as the starting point and always start the cut with the saw
chain running. Make the cut in such a way that the saw does not get jammed in the wood.
• Pay particular attention to branches under tension.
• Always pull the tool out of the wood when the saw chain is running.
• Never work with the tool above shoulder height or with only one hand.
• Always stand away from the falling direction. Position yourself on a slope above the tree to be felled.
• Always stand sideways when carrying out sawing work on a tree which is located on a slope,
never work from above or below.
• Always look out for the falling direction of the parts which are cut off.
• Never start the cut with the bar tip and never cut with the bar tip.
• Risk of kickback! There is always a risk of kickback when the bar tip touches the wood or other objects.
This makes the chainsaw uncontrollable and it may be thrown towards the operator with great force.
• Do not use the tool as a lever to move objects.
• Always use the chain guard during transport and storage.
• Secure the tool during transport in order to prevent loss of fuel, damage or injury.
• Warning! Keep passers-by away from running equipment but never work by yourself.
• Keep within earshot of others in case you need help.
• Stop the engine immediately when someone approaches you.
• Make sure that the saw chain does not come in contact with foreign objects such as stones, fences, nails
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
GB | 45