IKAR ASS-1 Prüfbuch Und Gebrauchsanleitung Seite 30

Follow these steps to assemble two IKAR HRA fall
arresting devices with rescue-lifting devices
Bolt the two mounting brackets to the cantilever lower arm using the
bolts provided. Insert the HRA device from above and lock into place
with the socket pin provided (
Pull out the socket pin from the upper arm locking mechanism and fold
the cantilever upper arm down. Pull out the socket pin on the lower
pulley and fold the pulley out and upwards.
Pull the cable and snap hook through and lay in the pulley. Then fold
back the pulley and lock into place with the socket pin.
Pull out the socket pin from the upper cable cover and fold cover plate
( )up. Pull the carabiner through and lay the cable in the pulley. Then
3
close the cover plate ( ) and lock in place with the socket pin. Hook
4
the snap hook into the eyelet.
The IKAR winch for loads and persons is assembled as
follows:
Pull out the socket pin and push the winch for loads with attached
mounting bracket onto the rear part of the upper arm (
Then secure the winch for loads inplace with the socket pin. Turn the
hand crank to unroll cable from the drum. Open the top rope cover
as described above, pull in the cable with the carabiner and close
( + ).
3 4
Similar to illustration
Equipment assembly ASS-1-ASS4
).
1
).
5
ENGLISH
1
3
5
The cable of the fall arresting device with rescue-lifting device
(HRA) pulls in automatically until the rescue lift function is
The instruction manual and safety instructions for the IKAR
fall-arresting devices with rescue-lifting device (HRA) and the IKAR
winch for loads and persons (PLW) must be observed.
30
2
4
Please note
activated.