Parkside PHSA 20-Li B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 23

Maintenance
Before any maintenance:
–
Switch the product off.
–
Remove the battery pack
–
Let the product cool down.
Before every use: Check the product for
defects such as loose, worn or damaged
parts.
Apply oil to the safety knife bar
can or spray (Fig. I and Fig. K).
Check that the screws in the safety knife
2 ] [
bar are tight.
Check covers and safety devices for
damages and correct installation. Replace
as necessary.
Troubleshooting
Problem
Product does not
start.
Intermittent operation
2 ] [
Safety knife bar
gets too hot.
The product cuts
poorly.
[ ]
.
[ 2 ]
by oil
Possible cause
[ ]
Battery pack is empty.
[ ]
Battery pack is not properly
inserted.
[ 4 ]
Safety switch not pressed
properly.
Internal wiring is defective.
The on/off switch
defective.
Too much friction due to lack of
lubrication.
Too much friction due to lack of
lubrication.
The safety knife bar
Suboptimal cutting technique.
Use a knife grinder to sharpen and smooth
out minor nudges on the cutting edge of the
safety knife bar
Contact a specialist to have a blunt, bent or
damaged safety knife bar
m
WARNING! RISK OF INJURY!
Do not try to install a safety knife bar
yourself. Installing a knife safety bar shall
only be done by a specialist.
Any maintenance and repair other than
described in this manual: Contact an
authorised service centre or a similarly
qualified person to check or repair the
product. Only use original parts.
Action
Charge battery pack
(see "Charging the battery
pack").
Insert battery pack
(see "Removing/inserting the
battery pack").
Switch the product on correctly
(see "Switching the product on/
off").
Send the product to Service
7 ] [ is
Centre for repair.
Oil the safety knife bar
Oil the safety knife bar
[ 2 ]
is dirty. Clean the safety knife bar
Adjust cutting technique
(see "Working instructions").
[ 2 ]
.
2 ] [
replaced.
[ ]
[ ]
correctly
2 ] [
.
[ 2 ]
.
2 ] [
GB
2 ] [
.
21