Parkside PHSA 20-Li B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 20

Charge the battery pack
operation when it is at medium or low
charging level.
The charging control LEDs (red
[ ]
green ) indicate the status of the charger
[ ]
and the battery pack
LED
Red LED lights up
Green LED lights up
Green and red LED
flashing
Red LED flashing
Green LED lights up
(without battery pack)
Insert the battery pack
[ ]
.
Connect the power cord with power plug
[ ]
of the charger
When the battery pack
–
Disconnect the power plug
[ ]
charger from the socket-outlet.
–
Remove the battery pack
[ ]
charger .
18 GB
[ ]
before
[ ]
and
[ ]
:
Status
Battery pack charges
Battery pack fully
charged
Battery pack defective
Battery pack too cold
or too warm
Charger ready
[ ]
into the charger
[ ]
to a socket-outlet.
[ ]
is fully charged:
[ ]
of the
[ ]
from the
Operation
m
WARNING! RISK OF INJURY!
Wear protective gloves!
Wear hearing protection!
Wear safety goggles!
Wear protective, slip resistant
footwear!
m ATTENTION!
Check the product for wear and tear
before each use.
The product will be switched ON when
the on/off switch
[ 4 ]
switch are held simultaneously. When
either one of the switches is released the
product will be switched OFF. Should
one of the two switches be damaged,
stop working with the product.
Switching the product on/off
m
WARNING! RISK OF INJURY!
Firmly hold the product with both hands
while directing the product away from the
body (Fig. D). Check that the product is
not in contact with other objects before
switching on.
Removing the blade guard
Unlock the blade guard
[ ]
.
Press
Pull the blade guard
[ 2 ]
bar (Fig. J).
7 ] [
and the safety
[ ]
: Press and hold
[ ]
off the safety knife