Silvercrest SNAW 1000 D2 Kurzanleitung Seite 14

The nutrition/energy value displays e now show all of the values, and the
food is now stored under the selected code .
10) Repeat steps 2) - 9) if you wish to enter more codes .
11) Enter the food in the appropriate field in the food tables of these operating
instructions .
NOTE
► You can also overwrite one of your previously saved codes by simply reas-
signing the code number and saving the new nutritional values under this
code .
► To stop saving your personal codes, press the ON/OFF button 9 to
switch off the appliance .
Replacing the batteries
If the appliance no longer works reliably, the display 3 becomes unreadable,
and/or "Lo" appears on the display, this means the batteries are exhausted and
need to be replaced with new batteries of the same type .
1) Open the battery compartment 2, remove the used batteries and dispose of
them in an environmentally friendly manner .
2) Insert two new 3 V CR2032 button cell batteries as per the polarity diagram
in the battery compartment 2 .
3) Close the battery compartment 2 . The battery compartment lid must click
into place .
SNAW 1000 D2
NOTE
► If "E" appears on the display 3 after entering a value, the value was
too high . The following maximum values can be entered:
PROT (protein)
FAT
CARB (carbohydrates)
KCAL (kilocalories)
CHOL (cholesterol)
► The appliance automatically calculates the values for kilojoules and
bread units from your entries .
500 .00 g
500 .00 g
500 .0 g
5000
5000 mg
GB │ CY │ 11 ■