Parkside PGHSA 12 A1 Originalbetriebsanleitung Seite 13

Further safety directions
• Comply carefully with maintenance,
control and service instructions in this
manual.
Damaged protective devices and parts
have to be repared or changed except
as noted otherwise in this manual.
• It is recommended that a fi rst-time user
at least practice the cutting of logs on a
saw log or frame.
• For sawing work on hillsides, always
stand in the area above the log.
To keep total control while sawing
through, reduce the pressure at the end
of the cut without loosening your grip
on the handles of the garden pruner.
Make sure the saw chain does not
touch the ground. After fi nishing the
cut, wait until the garden pruner comes
to a stop before removing it there. Al-
ways switch off the motor of the garden
pruner before changing between trees.
• Dirt, stones, loose bark, nails, clips and
wires must be removed from the tree.
• Do not use any accessories that are not
recommended by PARKSIDE. This can
result in electric shock or fi re.
Residual risks
Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Cuts
b) Ear damage if working without ear pro-
tection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic fi eld which, under certain circum-
stances, may impair the functionality of ac-
tive or passive medical implants. To reduce
the risk of serious or lethal injuries, we rec-
ommend that persons with medical im-
plants consult their doctor and the manu-
facturer of their medical implant before
operating the machine.
Observe the safety information and
notes on charging and proper use
as shown in the instruction manual
for your battery and charger from
the Parkside X 12 V Team series. A
detailed description of the charging
process and further information can
be found in the separate operating
instructions.
Assembly
Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself – injury hazard!
Before putting the electric chain saw into
operation, you must:
- adjust the saw chain tension,
- lubricate the saw chain
- charge and insert the battery
Assembling the blade
bar and saw chain
Switch off the device and remove
the battery before carrying out any
maintenance work.
GB IE NI
13