Vista Apex phasor Benutzerhandbuch Seite 5

PHASOR™ OPERATION
Inserting Composite
Snap a composite compule into the end of the device.
Position the compule so that the tip is directly under the LED lens.
• Short Compules: position forward
• Long Compules: position back
NOTE: The device will not operate in the absence
of a composite compule.
CAUTION: Parts of the composite compule may become hot.
Use caution and avoid touching the top of a hot composite compule.
Composite & Setting Compatibility
The chart below will list the ideal settings for most leading composite brands.
Contact Vista Apex at 877-418-4782 (Toll Free) for additional assistance.
OPTIMAL Setting
COMPOSITE BRAND SETTING 1
3M®*
DENTSPLY®*
Ivoclar®*
Kerr®*
VOCO®*
Coltene®*
Kuraray®*
GC®*
Shofu®*
Heraeus Kulzer®*
Tokuyama®*
Centrix®*
* 3M® is a registered trademark of 3M Company. Dentsply® is a registered trademark of DENTSPLY International. Ivoclar® is a registered trademark of IVOCLAR VIVADENT. Kerr® is a registered trademark of Kerr Corporation.
VOCO® is a registered trademark of VOCO AMERICA, INC. Coltene® is a registered trademark of COLTENE/WHALEDENT, INC. Kuraray® is a registered trademark of KURARAY CO., LTD. GC® is a registered trademark of GC
Corporation. Shofu® is a registered trademark of SHOFU, INC. Heraeus Kulzer® is a registered trademark of Heraeus Kulzer GmbH. Tokuyama® is a registered trademark of Tokuyama Corporation. Centrix® is a registered
trademark of Centrix, Inc.
CAUTION: Do not deviate from the recommended settings.
6
Compatible Setting DO NOT USE
SETTING 2 SETTING 3 SETTING 4
Selecting a Setting
Reference setting compatibility chart to determine
the appropriate setting per composite brand.
CAUTION: Do not deviate from the recommended settings.
Start Heating Cycle
Press & hold to enter programming mode.
This is indicated by flashing yellow lights.
Short press to toggle between settings.
1. 3.
2. 4.
Press & hold to exit.
Device will beep 3 times and shut off.
Your setting is now memorized as default.
Short press to start/stop heating cycle.
The blue lights will flash while heating.
Setting 1-3: 45 seconds
Setting 4: 70 seconds
The blue lights will turn solid when
heating cycle is complete.
The device will automatically shut off
after 3 minutes of sustained heating.
7