Scheppach HS110 Originalbetriebsanleitung Seite 39

6. Technical data
AC motor
Power
Idling speed
Carbide saw blade
Number of teeth
Thickness riving knive
Min. workpiece size
W x L x H
Table size
Cutting height max. 90°
Cutting height max. 45°
Height adjustment
Saw blade, swivelling
Extraction connection
Weight ca.
Subject to technical modifications!
*S1: Continuous operation with constant load
**Operating mode S6 40%: Continuous operation with
intermittent load (cycle time 10 min). In order not to heat
the motor more than permitted, the motor may only be
operated for 40% of the cycle time with the stated nom-
inal power and must then continue running for 60% of
the cycle time without a load.
Noise emission values
Sound values were measured in accordance with
EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
The effects of noise can cause a loss of hearing. Total
vibration values (vector sum of three directions) deter-
mined according to EN 62841.
230 V~ 50Hz
*S1 1600W
**S6 40% 2000W
4800 rpm
ø 254 x ø 30 x 2,8 mm
24
2,5 mm
10 x 50 x 1 mm
546 x 630 mm
87 mm
55 mm
0 - 87 mm
0 - 45°
ø 40 mm
19,5 kg
93,5 dB
3 dB
106,5 dB
3 dB
www.scheppach.com
NOTE: The specified device emissions values have
been measured in accordance with a standardised test
procedure and can be used for comparison of one pow-
er tool with another.
The specified device emissions values can also be
used for an initial estimation of the load.
m WARNING: The noise emission values can vary
from the specified values during the actual use of the
power tool, depending on the type and the manner in
which the power tool is used, and in particular the type
of workpiece being processed. Implement measures to
protect against noise nuisance.
In doing so, take into account the complete working
process, including the times when the power tool is
working without load or switched off. Suitable meas-
ures include regular maintenance and care of the pow-
er tool and the insertion tools, regular breaks as well as
proper planning of the working process.
7. Before putting into operation
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans -
port damage.
• If possible, store the packaging until the warranty
period has expired.
m ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
• The machine must be securely installed, i.e. bolted
down on a workbench, base frame or similar.
• Before the machine is put into operation, all covers
and safety devices must be properly attached.
• The saw blade must be able to move freely.
• In the case of wood which has already been worked
with, check for foreign bodies such as nails or
screws etc.
• Before pressing the on/off switch, make sure that
the saw blade is correctly attached and that moving
parts are free-running.
GB | 39