Training Of The Operator; Technical Data; Scope Of Delivery - Scheppach Ke 70m Anleitung

5. Training of the operator

• Forward the safety instructions to all people working on or with this machine.
• The minimum age for the operating person is 18 years. Trainees should be minimum 16 years of age, but are only
allowed to work with the machine under supervision.
• People running the machine should not be distracted.
• Keep children away from the to the net connected machine.
• Wear tight fitting clothes. Take off jewelry, rings and wristwatches.
• Observe all safety and hazard warnings on the machine and keep it in readable condition.
• Be careful at work: Danger of damaging finger(s) and hand(s) by the rotating cutting tool.
• Regular pauses must be observed during operation.
• Safety shoes and protective clothing must be worn during operation.

6. Technical Data

Article Number
Construction measurements:
Total length
Total width
Total height / Table height
Table size
Saw blade ø
Idle speed motor
Cutting speed saw blade
Weight
Power unit
Motor
Input power P1
Output power P2
Operating mode
Rated current
Work information
Cutting height Spar
Turning cut
Specific noise values
The according to the EN 23746 for the sound pressure level resp. EN 31202 (correction factor k3 after supplement A.2
from EN 31204 calculated) for the sound pressure level on the working site ascertained noise emission value amounts
under the foundations of ISO 7904 supplement a performed working conditions to.
Sound pressure level in dB
Idle L / Processing L
WA WA
Sound pressure level on working site in dB
Idle LqAeq / Processing LqAeq
The specified values are emission values and therefore should not at the same time be reliable working site values.
Although there is a correlation between emission and immision levels, it cannot unfailingly be derived if extra precautions
need to be taken or not. Factors, which influence the actual availabe immusion value on working site, include the peculi-
arities of working area, other sources of noise, e.g. the number of machines and other adjoining processes. The allowed
working values could vary from country to country. However, the information should qualify the user, to be able to make
an estimation of the dangers and risks..

7. Scope of delivery

• Roll table circular saw
• Allen key or open-end wrench
• Operating instructions
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Ke 70m
1905117902
mm 1460
mm 855
mm 1210 / 850
mm
mm
1/min 1380
m/sec
kg 172
380 - 400 / 50
V/Hz
kW
kW
S6 / 40%
A
max. mm 250
min. mm
max. mm
Reserve technical changes!
Ked 700
1905116902
1420
860
1250 / 850
1400 x 850
700
1380
51 51
149
380 - 400 / 50
5,2 5,2
4 4
S6 / 40%
16 16
230
60
250
Ke 70m Ked 700
93 / 99 102 / 104
86 / 91 80 / 82
GB 21