Parkside PFBS 12 C7 Originalbetriebsanleitung Seite 11

g) Never use damaged accessory tools. Before each use, check accessory tools such
as grinding discs for chips or cracks, sanding drums for cracks or excessive wear
and tear and wire brushes for loose or broken wires. If the power tool or the acces-
sory tool in use is dropped, check to see if it is damaged or use an undamaged
accessory tool. When you have checked and inserted the accessory tool, ensure
that you and any other people in the vicinity remain outside of the range of the
rotating accessory tool and allow the tool to rotate at maximum speed for one
minute. Damaged accessory tools usually break during this test period.
h) Wear personal protective equipment. Depending on the application, ensure that
you use full face protection, eye protection or goggles. If required, use a dust mask,
ear protectors, protective gloves or a special apron to protect you from grindings
and material particles. Protect your eyes from flying debris that may be created during
certain applications. Dust or filter masks must be used to filter any dust created by the
application. If you are exposed to loud noise for any length of time, you may suffer
hearing loss.
i) Ensure that other people remain at a safe distance from your workspace. Anyone
who enters the workspace must wear personal protective equipment. Fragments of
the work piece or broken accessory tools can fly off and cause injury – even outside the
immediate working area.
j) Hold the power tool only by the insulated gripping surfaces when performing an
operation where the accessory tool may contact hidden wiring or its own cord.
Contact with a live cable can also make metal parts of the appliance live and could
result in an electric shock.
k) Always hold the power tool firmly. When running up to full speed, the torque of the
motor can cause the power tool to twist.
l) If possible, use clamps to hold the workpiece in position. Never hold a small work-
piece in one hand and the power tool in the other while you are using it. By
clamping small workpieces, you keep both hands free for better control of the power
tool. When cutting round workpieces such as dowels, rods or pipes, be aware that
these can roll away and this can cause the tool to jam and be thrown towards you.
m) Hold the power cord away from any rotating accessories. If you lose control of the
appliance, the cord may get cut or caught and your hand or arm could get caught in the
rotating accessory tool.
n) Never put the power tool down until the accessory tool has come to a complete
standstill. The rotating accessory tool can come into contact with the surface and cause
you to lose control of the power tool.
o) When changing accessory tools or changing settings, tighten the collet nut, the
chuck or other fixing elements tightly. Loose fastening elements can shift unexpectedly
and lead to loss of control; unsecured, rotating components will fly off violently.
│ GB │ IE
■ 8 PFBS 12 C7