BWT STANDARD Installations- Und Anwendungshandbuch Seite 55

7. SANITIZATION OF REVERSE OSMOSIS FILTER
6. Disconnect the tube going to the storage tank from the union tee
before the carbon post-filter, and into 3
7.
Put a disinfection tablet in the 1
8.
After 15 minutes, open tank valve
5
9.
Open the feed valve
6
10.
Close the tank valve
6
11.
Open tank valve and drain all water from the tank to the sink. Disconnect it from the third pre-filter and restore the
original tubing of the system.
12.
Put cartridges in sumps and install the sumps on their heads. Then, open tank valve 6 and feed valve
13.
Drain the tank and re-fill for at least three times (until chlorine odor cannot be smelt).
Code P0090636 - Rev 0 - 19/06/2019
rd pre-filter's outlet.
st sump. Fill the sump with water and screw on.
6
.
for 5 minutes.
and leave the tank filled with chlorine solution for 1-2 hours.
6
.
55