ims PRO NEOCUT 105 Bedienungsanleitung Seite 32

- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported.
32
NEOCUT 105 / 125
Arc stops after 3 seconds of cutting
The machine does not switch on.
The pilot-arc cuts out too quickly
The arc stops mid-way through
cutting
Premature wear of consumables
No current detection in the earth
clamp
No power supply
Used consumables
Cutting speed too low on thin
sheets
Contact on the low-quality earth
clamp
Cutting height too high
Cutting current inappropriate for
consumables used
Inappropriate air pressure
Humid air
EN
Check that the earth clamp is connected
to the cutting part on a clean area (no
rust, paint or grease).
Check that the power cord of the pro-
duct is plugged into the outlet and that
the power switch is in the on position.
Check that the circuit-breaker has not
tripped.
Check the condition of the consumables
and replace if necessary.
Reduce the current / increase the
movement speed.
Check that the earth clamp is connected
to the cutting part on a clean area (no
rust, paint or grease).
Use a cutting pad and keep it in contact
with the part to be cut.
Refer to the chapter "Setting the cutting
current".
Refer to the chapter "Adjusting the air
pressure".
Purge the air filters from the station and
the compressed air network. Add the
additionnal Air filter ref. 039728.