ims PRO NEOCUT 105 Bedienungsanleitung Seite 25

HMI NAVIGATION
SCROLL WHEEL USE
Turning the scroll wheel allows
- an adjustment of a digital parameter (current, pressure)
- moving the cursor to make a selection
Pressing the scroll wheel
- allows to confirm a selection (pointed by the cursor)
- access the toolbar from the main screen or from the pressure setting screen
MAIN SCREEN (CURRENT SETTING):
6.0m
1 3
105
A
5.2 bar
2 4
*An arrow pointing up or down may appear to the right of the pressure when the pressure has been incorrectly altered by the user, the arrow disappears when the set
pressure is optimal or the pressure setting is set in «auto» mode.
TOOLBAR (ACCESS VIA SCROLL WHEEL)
1
2
105A
3
5.2 bar
Setup 4
MODE SELECTION
Cutting
PRESSURE ADJUSTMENT
6.0m
1 3
AUTO
105 A
2 4
NEOCUT 105 / 125
This screen is displayed as soon as the machine is started:
1- Operating mode
2- Current pressure*
3- Selected torch length
4- Current
The current setting is made directly from this screen.
1- Access to the mode selection screen
2- Access to the main screen (current setting)
3- Accessing the pressure adjustment screen
4- Access to the Setup menu
6 modes are available. To make the right choice, please refer to the chapter «mode selection».
By default, the screen looks like this:
1- Operating mode
2- Current
3- Torch length
4- Pressure*
*Pressure is automatically locked as default (indicated by the inscription AUTO and the closed padlock): the machine
takes care of setting the right pressure value according to various parameters (such as current, mode, torch length).
EN
25