ims PRO NEOCUT 105 Bedienungsanleitung Seite 30

GOUGING:
With the earth clamp fastened to the part, keep for torch at a 45° angle to the
1 piece, while maintaining the special gouging shield roughly 2mm away from the
part before starting the torch.
Press the torch trigger before starting the arc while maintaining it at an angle of
2
45° to the piece while cutting through the groove
Push the plasma arc in the direction you wish to cut. The distance between the
3 torch shield and the melted metal should be as little as possible in order to avoid
premature wear of the consumables or damage to the torch.
Speed
Torch-part
distance
CHANGING THE SHAPE OF THE GROOVE
Width
Depth
Increase the
Solutions
PROTECTION
Safety features prevent the product from working, but are usually due to an operating error, an oversight on the part of the user or an environmen-
tal problem. The following table guides the user to solve the problem himself.
Icon at the onset of
safety
Torch missing
Unknown torch
Nozzle missing
30
NEOCUT 105 / 125
Angle
Increase the
Reduce the
torch-piece
speed speed
distance
Reminder icon Meaning
Torch disconnected
Torch unrecognized
Dismantled nozzle
GROOVE SHAPE
You may modify the profile of the groove by adjusting the speed, the angle or the
distance of the torch on the metal piece, or the power output on the machine.
Decrease the
Increase the
torch-piece
angle
distance
Connect a torch. If the problem persists when a torch is connected,
check the cables or replace the torch.
Connect a torch compatible with the product. If the problem per-
sists when a torch is connected, check the cables or replace the
torch.
Check that all consumables are present and screw the nozzle back
on.
Reduce the Increase the Decrease the
angle current
Solutions
EN
current