ims PRO NEOCUT 105 Bedienungsanleitung Seite 28

UNITS
m. /bar
ft./psi
LOCKING
LOCKING
LOCK
1
2
PASSWORD
3
EXIT
Choosing the password
Unlocking
5.2 bar
CUTTING SEQUENCE
1- When the trigger is pressed, the pilot-arc starts. It is a low power arc generated between the electrode and the nozzle and it allows the arc to
start on the piece of metal to be cut.
2- When the pilot-arc touches the plate, the plasma cutter detects the start. The arc then flows between the electrode and the plate, and the
machine increases the current up to the value set by the operator.
3- At the end of cutting (trigger release or unblocking), the arc stops, the air continues to come out for several dozens of seconds to cool the torch
and consumables down.
DISPLAYED WHILE CUTTING
1
7.3 bar 152V
105
4
105A
5
5.0 bar
28
NEOCUT 105 / 125
Allows you to change the current units:
- SI units: torch length expressed in meters and pressure in bar
- Imperial units: torch length in feet and pressure in PSI
1- Activates the HMI lock and return to the main screen
2- Password change access
3- Exit the menu (without locking)
PASSWORD
0___
6.0m
105
A
1- Current mode
2 3
2- Pressure coming in
3- Arc voltage
4- Current set
5- Pressure going out
A 6
6- Current measured
Turn the turn dial to select the first digit and confirm by pressing the wheel.
Repeat the process for the remaining three digits.
When the password has been changed, the display will return to the LOCKING
menu with the cursor positioned on 'LOCK'. The default password is 0000.
The padlock symbolises that the screen is locked.
To unlock the screen, press and hold the turn dial until the countdown is com-
plete (three seconds). Enter the password to unlock the machine.
After incorrectly entering your password three times, the interface will be
blocked and will ask for a six digit unlocking code (SUPER PASSWORD). This
non-modifiable code is: 314159.
EN