ims PRO NEOCUT 105 Bedienungsanleitung Seite 24

AIR PRESSURE ADJUSTMENT
The NEOCUT is equipped with an electronicallycontrolled pressure regulator, the pressure is adjusted via the HMI (see following pages).
In order to obtain optimal performance and service life of the consumables, it is very important :
- To define the right torch length
- To use the adapted mode for the chosen consumables
- To use the appropriate current for the chosen consumables
- Leave the pressure setting on «auto».
It is recommended to check that the parameters entered on the HMI are in line with the actual configuration, especially in the case of:
- Connection point or pneumatic installation changes
- Torch length change
- Consumable type change
- Doubt.
It is possible to check the pneumatic circuit using the «air test» function, this allows, among other things, to check whether the pressure supplied
by the compressor is sufficient (see following pages).
CUTTING MODE CHOICE
Cutting / cutting with locked trigger
Use one of these two modes to perform your cutting work on solid sheet metal.
Pull the trigger to create the arc, and release it to stop or «unlock» (the arc stops by itself).
For long cuts it is possible to use the locked trigger mode, in which case the trigger can be released during cutting. This mode
prevents fatigue and keeps your hand a little further away from the cutting area.
Gouging / gouging with locked trigger
Use one of these two modes to perform your gouging work.
Pull the trigger to create the arc, and release it to stop or «unlock» (the arc stops by itself).
For long cuts it is possible to use the locked trigger mode, in which case the trigger can be released during cutting. This mode
prevents fatigue and keeps your hand a little further away from the cutting area.
Cutting of perforated metal sheets
Use this mode to perform cutting work on perforated metal sheets that require repetitive cutting stops / restarts.
This is a cutting mode where the arc recharges itself as long as the trigger is held down. This mode is more comfortable to
use, as it avoids constant pull and release of the trigger.
Marking out
This mode, compatible with all cutting consumables, operates at low current and allows surface marking of sheet metal.
Particularly useful for automated cutting to record for example references, bundle numbers... this mode is also accessible with
a manual torch.
FIRST START UP
At first startup, the machine will ask you to configure the following parameters:
(EN) ENGLISH
(FR) FRANCAIS
(DE) DEUTSCH
1
(IT) ITALIANO
(ES) ESPANOL
(NL) NEDERLANDS
(RU) RUSSKIY
Language
3 MT/AT-125
MT/AT-160
Torch model
(NEOCUT 125 only)
Rotating the scroll wheel moves the cursor in front of the desired selection, pressing the scroll wheel validates the selection.
24
Note: In the event of an input error, these parameters can be changed (see Setup menu).
NEOCUT 105 / 125
2 m. /bar
ft./psi
Units (m./bar or ft./psi)
6.0-7.6m/20ft-23ft
12.0m/40ft
4
15.2m/50ft
20.0m/66ft
Torch length
3-4 :
Important setting for the correct
operation of the product. This data is
used by the power source to calculate
and apply the optimum operating pres-
sure.
EN