ims PRO NEOCUT 105 Bedienungsanleitung Seite 27

To carry out a reset, select the desired line by turning the scroll wheel and press and hold down (a countdown is displayed to
the right of the selected line), at the end of the countdown the selected line is reset to zero.
Releasing the scroll wheel during the countdown cancels the action.
Note: this function is to assist with monitoring the consumables for wear and tear. The user is not obliged to use this function
and even less to reset the counters each time the consumable is changed (the machine does not lock up if the number of
cycles or operating times is too high).
AIR TEST
VALUE =5 bar
INPUT =-.-bar
OUTPUT =-.-bar
TORCH LENGTH
MT/AT-125
MT/AT-160
6.0m/20ft
7.6m/25ft
12.0m/40ft
15.2m/50ft
LOG
IND PCB : XX.XX
EVO PCB1 : XX
EVO PCB2 : XX
SOFTWARE : XX.XX
POWER ON : XXX
CUT TIME : XXX.XH
CUT COUNT : XXX
LANGUAGE
(EN) ENGLISH
(FR) FRANCAIS
(DE) DEUTSCH
(IT) ITALIANO
(ES) ESPANOL
(NL) NEDERLANDS
(RU) RUSSKIY
NEOCUT 105 / 125
This tool allows to force the air out of the power source to :
- purge the circuit in case of presence of moisture in the circuit.
1
- check whether the compressor performance is sufficient
2
1- Test pressure adjustment
2- Display of the pressure at the product inlet
3
3- Product outlet pressure display
Pressing the scroll wheel turns off the air and returns to the Setup menu.
Selects the torch model (only for NEOCUT 125)
Important setting for the correct product operation. This data is used by the power source to
calculate and apply the optimum operating pressure.
Allows to change the length of the torch
Important setting for the correct product operation. This data is used by the power source to
calculate and apply the optimum operating pressure.
Displayed in the logbook :
1
1- Version of the electronic boards
2- Version of the software
2
3- Number of times the machine was switched on
3
4- Total cutting time
4
5- Number of cutting cyclese
5
Allows you to change the current language
EN
27