ims PRO NEOCUT 105 Bedienungsanleitung Seite 29

MANUAL CUT FROM THE EDGE OF THE WORKPIECE:
The earth clamp attached to the metal piece, hold the torch pad in perpendicular
1
position (90°) to the end of the workpiece.
Pull the trigger of the torch to prime the arc until the torch has completely pass
2
through the part.
Once the cutting has started, drag the pad slightly on the metal sheet to continue
3
cutting. Try to maintain a regular rhythm.
START CUTTING INSIDE THE METAL SHEET:
With the earth clamp attached to the metal piece, maintain the torch at an angle of
1
roughly 30° to the piece.
Press the torch trigger to start the arc while maintaining an angle of 30° to the
2
part. Slowly rotate the torch towards a perpendicular position (90°).
Immobilise the torch while keeping the trigger pressed. If the sparks come from
3
below the metal piece, the arc has cut the material.
4 Once the cutting has started, drag the pad slightly on the metal sheet to continue cutting. Try to maintain a regular rhythm.
NEOCUT 105 / 125 EN
29