Ferm Ferax FVS-950 Handbuch Seite 38

GB
Special safety instructions
• Check that the maximum speed indicated
on the grinding disc corresponds to the
maximum speed of the machine. The
speed of the machine must not exceed the
value on the grinding disc.
• Make sure that the dimensions of
the grinding disc correspond to the
specifications of the machine.
• Make sure that the grinding disc has been
mounted and fastened properly. Do not
use reducing rings or adapters to make the
grinding disc fit properly.
• Treat and store grinding discs in
conformance with the supplier's
instructions.
• Do not use the machine for grinding
workpieces with a maximum thickness
exceeding the maximum grinding depth of
the grinding disc.
• Do not use grinding discs for deburring.
• When grinding discs have to be mounted
on the thread of the spindle, make sure
that the spindle has sufficient thread.
Make sure that the spindle is sufficiently
protected and does not touch the grinding
surface.
• Before use, inspect the grinding disc for
any damage. Do not use grinding discs
which are crack-ed, ripped or otherwise
damaged.
• Before use, let the machine run idle for
30 seconds. Immediately switch off the
machine in case of abnormal vibrations
or occurrence of another defect. Carefully
inspect the machine and grinding disc
before switching the machine on again.
• Make sure that sparks do not put people
into danger or that they contact highly
flammable substances.
• Make sure that the workpiece is sufficiently
supported or clamped. Keep your hands
away from the surface to be cut.
• Always wear safety goggles and hearing
protection. If desired or required also use
another kind of protection like for example
an apron or helmet.
• Ensure that mounted wheels and
points are fitted in accordance with the
manufacturer's instructions.
• Ensure that blotters are used when they
are provided with the bonded abrasive
product and when they are required.
• If a guard is supplied with the tool never
38
use the tool without such a guard.
• For tools intended to be fitted with
threaded hole wheel, ensure that the
thread in the wheel is long enough to
accept the spindle length.
• Ensure that ventilation openings are kept
clear when working in dusty conditions. If
it should become nessesary to clear dust,
first disconnect the tool from the mains
supply (use non metallic objects) and avoid
damaging internal parts.
• Though poor conditions of the electrical
mains, shortly voltage drops can appear
when starting the equipment. This can
influence other equipment (eq. blinking
of a lamp). If the mains-impedance Zmax
<0.348 Ohm, such disturbances are not
expected. (In case of need, you may
contact your local supply authority for
further information.
Electrical safety
When using electric machines always observe
the safety regulations applicable in your country
to reduce the risk of fire, electric shock and
personal injury. Read the following safety
instructions and also the enclosed safety
instructions.
 A lwayscheckthatthepowersupply
corresponds to the voltage on the
rating plate.
Your machine is double insulated;
thereforenoearthwireisrequired.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It
is dangerous to insert the plug of a loose cable
in the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The
minimum conductor size is 1.5 mm
using a cable reel always unwind the reel
completely.
3. ASSEMBLY
 P riortomountinganaccessoryalways
unplug the tool.
. When
2
Ferax