Hettich ROTOFIX 32 A Gebrauchsanweisung Seite 70

Software operation
7.1.4 Centrifuging radius
7.2 Rotor detection
7.3 Machine Menu
7.3.1 Audible signal
7.3.1.1 General
28 / 38
For example: Maximum speed 4000 RPM, density 1.6 kg/dm³
If, in exceptional cases, the maximum load indicated on the bucket is
exceeded, the speed must also be reduced. The permissible speed can
be calculated using the following formula:
For example: Maximum speed 4000 RPM, maximum load 300 g, actual
load 350 g
Please contact the manufacturer if you are not sure.
The centrifuging radius must be entered in centimetres.
1. Switch off the mains switch.
2. Press and hold down the ▲
[IMPULSE] button simultaneously.
3. Switch on the mains switch and release the buttons.
[RPM/RCF x 100] button repeatedly until the centrifuging
4. Press the ▲
'rd' are displayed.
radius and
5. Use the [t] buttons to set the desired centrifuging radius.
[STOP] button to save the settings.
6. Press the
■
Rotor detection is performed after starting a centrifugation run.
■
If the rotor has been changed, the centrifugation run is cancelled after
rotor detection. The rotor code (red) is displayed.
■
If the maximum speed of the rotor used is less than the set speed, the
speed is limited to the maximum rotor speed.
The audible signal sounds:
■
after a problem occurs in the 2 s interval.
■
after completion of the centrifugation run and rotor standstill in the 30 s
interval.
Opening the lid or pressing any button stops the audible signal.
Rev.: 00 / 11.2023
[RPM/RCF x 100] button and the
AB1207en