Hettich ROTOFIX 32 A Gebrauchsanweisung Seite 57

4 Transport and storage
4.1 Transport and storage conditions
Transport conditions
Storage conditions
4.2 Fastening the transport lock
AB1207en
The original transport locks must be attached for return shipment, see
Chapter 4 'Transport and storage' on page 15 . The device must be
⮫
shipped in its original packaging.
NOTICE
Damage to the device due to failure to use the transport
locks.
−
Secure the transport locks before transporting the
device.
NOTICE
Damage to the device due to condensation.
There is a risk of condensation forming on electrical com-
ponents when component surfaces are cold and the sur-
rounding air is warmer. The condensation that forms may
cause a short circuit and/or destroy electronics.
−
Warm the device up for at least 3 hours in a warm room
before connecting it to the mains.
or
−
Warm up for 30 minutes in a cold room.
■
Before transporting, fasten the transport lock and disconnect the device
from the mains socket.
■
The transport temperature must be between -20 °C and +60 °C.
■
Humidity must not be condensing. Humidity must be between 10% and
80%.
■
Be aware of the weight of the device.
■
When transporting using a transport aid (e.g., a pallet truck), the trans-
port aid must be able to carry at least 1.6 times the transport weight of
the device.
■
Secure the device to prevent it tipping over and falling down during
transport.
■
Never transport the device sideways or upside down.
■
The device must be stored in the original packaging.
■
Only store the device in dry rooms.
■
The storage temperature must be between -20 °C and +60 °C.
■
Humidity must not be condensing. Humidity must be between 10% and
80%.
Personnel:
■
Trained user
The lid is closed.
The mains cable is disconnected from the device.
Rev.: 00 / 11.2023
Transport and storage
15 / 38