Hettich ROTOFIX 32 A Gebrauchsanweisung Seite 59

5.2 Removing the transport lock
5.3 Setting up and connecting the centrifuge
Setting up the centrifuge
AB1207en
3. Remove the accessories and store them safely.
4. Place the device on a stable and level surface.
Personnel:
■
Trained user
The lid is closed.
The mains cable is disconnected from the device.
1
2
3
Fig. 14: Transport lock
1 Transport lock
2 Spacer sleeves
3 Screws
1. Tilt the device on the back of the device.
2. Unscrew 3 screws (
3. Remove 3 transport locks (
4. Keep the screws, spacer sleeves and transport lock in a safe place.
WARNING
Risk of injury due to failing to maintain a sufficient distance to
the centrifuge.
−
As per EN / IEC 61010-2-020, no persons, hazardous
materials or objects may be present within a safety zone
of 300 mm around the centrifuge during a centrifugation
run.
−
A distance of 300 mm from the ventilation slots and ven-
tilation openings of the centrifuge must be maintained.
CAUTION
Risk of crushing and damage to the device due to it falling
down because of vibration-induced position alterations.
−
Place the device on a stable and level surface.
−
Select the installation surface dependent on the weight
of the device.
Rev.: 00 / 11.2023
2
2
3 ) with spacer sleeves ( 2 ).
1 ) and store them safely.
Commissioning
3
2 3
17 / 38
1