Hettich ROTOFIX 32 A Gebrauchsanweisung Seite 56

Device overview
Fig. 10: [STOP] button
Fig. 11: [RPM/RCFx100] button
Fig. 12: [t] button
3.6 Original spare parts
3.7 Scope of delivery
3.8 Returns
14 / 38
■
End the centrifugation run.
The rotor ramps down to a stop at the preselected brake level.
■
Save the brake level and centrifuging radius.
■
A numerical value from 500 RPM to the maximum rotor speed can be
set.
Adjustable in increments of 100 (RPM = displayed value x 100).
■
Display the brake level and centrifuging radius.
■
Enter runtime.
Adjustable from 1 to 99 minutes in 1 minute increments.
■
Centrifuging radius.
Input in centimetres. Adjustable from 5 to 16 centimetres, in 1 centi-
metre increments.
■
Brake level 0 or 1.
Level 1 = short ramp-down time
Level 0 = long ramp-down time.
Use only original spare parts from the manufacturer and approved accesso-
ries.
The following accessories are supplied with the centrifuge:
■
1 Release pin
■
1 hex key (SW5 x 100)
■
1 grease for the trunnions
■
1 power cable
■
2 Fuse links
■
1 user manual
■
1 instruction sheet, transport lock
Rotors and the corresponding accessories are supplied depending on the
order.
An original Return Material Authorisation (RMA) form from the manufacturer
must always be requested for a return. Secure and reliable acceptance and
booking in of the goods with the manufacturer is not possible without an
original RMA form from the manufacturer. The Return Material Authorisation
(RMA) form contains a Declaration of No Objection (UBE), which must be
completed in full and enclosed with the return.
If the device and/or accessories are returned to the manufacturer, the
complete return shipment must be cleaned and decontaminated by the
sender. If returns are not cleaned and/or decontaminated or are insuffi-
ciently cleaned and/or decontaminated, this will be performed by the manu-
facturer and charged to the sender.
Rev.: 00 / 11.2023 AB1207en