Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Clean theTransfer Ribbon Drawing Roller
A soiled drawing roller can lead to reduced print quality and can affect transport of material.
•
Open the cover of print module.
•
Remove labels and transfer ribbon from the print mechanics.
•
Remove deposits witht roller cleaner and a soft cloth.
•
If the roller appears damaged, replace it.
•
Reload labels and transfer ribbon.
•
Close the cover of the print module.
Clean the Printhead
CAUTION!
Wrong cleaning auxiliaries can damage the printhead!
Do not use sharp or hard objects to clean the printhead.
Do not touch protective glass layer of the printhead.
Printing can cause accumulation of dirt at printhead e.g. by colour particles of transfer ribbon, and therefore it is necessary to
clean the printhead in regular periods depending on operating hours, environmental effects such as dust etc.
•
Open the cover of print module.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove labels and transfer ribbon from the print mechanics.
•
Clean the printhead surface with a special cleaning pen or a cotton swab dipped in pure alcohol.
•
Before using the printing system, let the printhead dry for about two to three minutes.
•
Reload labels and transfer ribbon.
•
To move the printhead down, turn the pressure lever in clockwise direction until it locks.
•
Close the cover of the print module.
Clean the Label Photocell
CAUTION!
Abrasive cleaning agents can damage the label photocell.
Do not use sharp or hard objects or solvents to clean the label photocell.
The label photocell can be soiled with paper dust. This may affect the label scanning.
A
•
Open the cover of print module.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove labels and transfer ribbon from the print
mechanics.
•
Blow out the photocell (A) with the compressed air
B
spray. You have strictly to observe the instructions
mentioned on the can.
•
Moisten a cleaning card (B) with printhead and roll
solvent to clean additionally the photocell inside.
•
Reload labels and transfer ribbon.
•
To move the printhead down, turn the pressure lever in
clockwise direction until it locks.
•
Close the cover of the print module.
English
SPX II
137
Werbung
