Carl Valentin SPX II Serie Kurzanleitung Und Hinweise Zur Produktsicherheit Seite 127

Service Functions
NOTICE!
So that the distributor res. the manufacturer in case of service can offer fast support the necessary information such
as selected parameters can be taken directly from the service functions menu of the device.
Keys: , , ,
Label parameters
Taste:
Photocell settings
Key:
Photocell parameters
Key:
Paper counter:
Key:
Heater resistance
Key:
Printhead temperature
Key:
Motor Ramp
Key:
Print examples
Key:
Input
, , , ,
Indication of label parameters in Volt.
A: Indication of minimum value.
B: Indication of maximum value.
C: Indication of trigger level. The value is ascertained while measuring and can be changed.
This function enables definition of photocell levels.
In case of problems while positioning or measuring of label, levels for label photocell can be set
manually. Make sure that a large hub as possible (label >3 V, gap <1 V) is set.
TLS: Indication of transmission photocell level in Volt.
RLS: Indication of reflexion photocell level in Volt.
SLS: Indication of peel off photocell level in Volt.
RC: Indication of transfer ribbon photocell status (either 0 or 1).
H: Indication of printhead position.
0 = printhead down
1 = printhead up
D: Indication of printhead attainment in meters.
G: Indication of device attainment in meters.
To achieve a high print quality, the indicated Ohm value must be set after replacing the
printhead.
Indication of printhead temperature. The printhead temperature corresponds normally to the
room temperature. In case the maximum printhead temperature is exceeded, the current print
order is interrupted and an error message appears at the printer display.
This function is often used for high printing speed as the tearing of transfer ribbon can be
prevented.
The higher the '++' value is set, the slower the feeding motor is accelerated.
The smaller the '− −' value is set, the faster the feeding motor is decelerated.
Select this menu item to get a printout with all settings.
Settings:
Printout of all device settings such as speed, label and transfer ribbon material.
Bar codes:
Printout of all available bar code types.
Fonts:
Printout of all available font types.
Indication of level for IO parameters input.
0 = Low
1 = High
English
, , ,
SPX II
127