Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SPX II
Key:
Manual reprint
Key:
Backfeed/Delay
Key:
Label confirmation
Key:
Standard label
Key:
Synchronization at
switching on
Key:
CMI length
122
Yes: I In case an error occurred and the print module is in stopped mode then you can reprint
the last printed labels by means of keys
No: Only blank labels were advanced.
Backfeed: The backfeed was optimised in the operating mode dispenser. Now, when driving
into the offset, the following label is 'pre-printed' if possible and therefore the backfeed of label is
no necessary and time can be saved.
Delay: The adjustable deceleration time is only for mode Backfeed automatic of importance.
On: A new print order is only printed after confirmation at the device.
An already active continuing print order is printed as long as the confirmation is effected at the
device.
Off: No query appears at the display of control unit.
On: If a print order is started without previous definition of label, the standard label is printed.
Off: If a print order is started without previous definition of label, an error message appears in
the display.
Off: The synchronization is disabled, i.e. the measuring and label feed have to be released
manually.
Measure: After switching on the printer, the loaded label is automatically measured.
Label feed: After switching on the printer the label is synchronised to the beginning of label. For
this one or multiple labels are advanced.
If the print is interrupted in the label, at the printhead this could lead to a small interruption in the
printout, showing a fine white line onto the label. To avoid this, a value for the minimum
backfeed can be set (0 – 1 mm) at which the label material is moved backwards. At the next
print start the free range is overprinted. The setting of CMI length has only an influence at the
selection of backfeed mode 'optimised backfeed'.
English
and
.
Werbung
