Stiga MH 500 Li 48 Gebrauchsanweisung Seite 119

PROJECTION HAZARD! Be
careful of flying debris projected
by the cutting means, that
can cause serious injuries to
persons or damage to things.
PROJECTION HAZARD! Keep
people or pets at least 15 m
away when using the machine!
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised service centre.
3.3 PRODUCT IDENTIFICATION LABEL
The product identification label
provides the following data (fig. 1 ):
1. Sound power level
2. Conformity marking
3. Month/Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
7. Article code
8. Voltage and Frequency of power supply
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on the
product identification label whenever you contact
an authorised service centre.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.
3.4 MAIN COMPONENTS
The machine is composed of a series
of main components that have the
following functions (fig.1 ):
A. Motor: supplies the drive power
to the cutting means.
B. Control Rod: hand grip fitted with
the main throttle controls.
C. Rear hand grip: support hand grip
located on the rear of the control rod. This
should be grasped using the right hand.
D. Front hand grip: support hand grip
located on the control rod. This should
be grasped using the left hand.
E. Hedge trimmer device device used
for trimming and pruning trees. Already
mounted on the rod when supplied.
F. Harness: a fabric belt which, placed
over the shoulders, helps support the
weight of the machine during work.
G. Blade (cutting means): the element
designed to cut the vegetation.
H. Blade guard (for machine transport and
handling): protects against accidental
contact with the cutting devices
that can cause serious injuries.
I. Battery: (if non provided with the machine,
see chap. 15 "accessories upon request"):
device that supplies electric current to the
tool; its specifications and regulations for
use are described in a specific manual.
J. Battery charger (accessory available
upon request, par. 15.2): device used to
recharge the battery; its specifications
and directions for use are described in
a specific manual. Two battery chargers
are available: J1 (fast battery charger);
J2 (standard battery charger).
4. ASSEMBLY
The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or dangers.
For storage and transport purposes, some
components of the machine may not be installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the instructions provided in the
"ASSEMBLY" section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
EN - 5