baltur TBML 50 ME Bedienungsanleitung Seite 10

BURNER CONNECTION TO THE BOILER
assemBLing THe HeaD UniT
- position the insulating gasket 3 on the sleeve, inserting rope 2
between flange and gasket.
- loosen screws "6", adjust the position of the connection flange
"5" so that the combustion head penetrates the furnace up to
the length recommended by the generator manufacturer.
- Fasten the burner 4 to the boiler 1 by means of the stud
bolts,washers and the nuts provided.
Completely seal the space between the tube unit of the
burner and the hole in the refractory panel using suitable
materials to do so.
assemBLing THe gas Train
There are two solutions for assembling the valve train 8 and 8a as
shown in the drawing. Choose the most rational position for the set-up
of the boiler room and the position in which the gas pipeline arrives.
8 / 30
0006160034_201307