Normal Operation; Operating Individual Devices; All Off" Function; Epg - Electronic Programme Guide - Medion MD 83533 Bedienungsanleitung

Normal operation

Operating individual devices

After you have finished programming your remote control for your audio/video devices, the remote con-
trol will work in the common main functions just like the original remote control of the respective de-
vice.
Point your remote control at the desired device and press the relevant source key. The key will light up
briefly but will not remain lit.
Activate the functions by pressing the corresponding function key of your universal remote control. The
source key will light up briefly each time the key is pressed.
Please note:
In certain circumstances, not every function of your original remote control may be directly available
on the universal remote control.
Especially for newer devices, it might be possible that the functions are stored to different keys than
expected or may not even be available at all.

"All off" function

You can switch off all pre-programmed devices at the same time. This is done as follows:
Briefly press the
light up.
Immediately press the
programmed devices will be switched off consecutively. This takes about 3 seconds.
If a default device was switched off, it can be switched on via the "All off" function.
EPG – Electronic Programme Guide
The ("Electronic Programme Guide") key has various functions depending on which code has been
EPG
used:
The button will open the electronic television channel in the case of TV and satellite codes (e. g. SAT-TV
or DVB-T).
For DVD codes the button opens the title menu.
You will be able to program with the button in the case of VCR codes, provided that your video recorder
has a showview function.

Universal functions ("Punch Through")

The universal functions (also called "Punch Through" functions) enable you to carry out certain functions
on a different device type than the programmed one. These are the volume, mute and playback func-
tions.
If the remote control is in VCR, DVD, SAT or CBL mode, the volume and mute keys control the TV set
(provided the other devices do not have their own volume control);
if the remote control is in TV mode or in another mode without playback function, the Play, Pause, Stop
and perhaps Record will actuate any video recorder, DVD player or DVD recorder which is connected.
The last selected device is actuated.
Programming the volume/mute universal functions for another or a particular type
of unit
In its delivered state, the universal remote control is programmed in such a way that the volume and
mute functions automatically control the TV set if a source key for a device with image transmission
(DVD, video recorder) is pressed.
You can program the universal remote control so that the universal functions "Volume" and "Mute" will
actuate another device type than the TV set.
Keep the key pressed down for approx. 3 seconds until the background lighting of the source
CODE
key briefly flashes and then remains on.
Keep the (
MUTE
40
( ) key. The selected device switches off and the relevant source key will
STANDBY
( ) key again and keep it pressed for 3 seconds. Now all pre-
STANDBY
) key pressed down until the blue LED goes off.