Manual Code Search; Automatic Search - Medion MD 83533 Bedienungsanleitung

Manual code search

Carry out a manual search as follows:
Switch the relevant device on manually.
Briefly press the required source key (
Keep the key pressed for approx. 3 seconds until the blue LED remains solid.
CODE
Keep pressing (up to 350 times)
switches off, changes channels, or responds accordingly.
The code search begins at the currently stored number.
Briefly press
ENTER
Due to the considerable quantity of different code numbers, up to 350 different codes are pre-
programmed per device type. In individual cases it may be possible that only the most common main
functions are available. The process described here may not work for some special models.

Automatic search

If your device does not respond to the remote control, even though you have tried all of the codes listed
for your device type and the relevant brand, then try using the automatic search. This will enable you to
find codes for brands that were not listed in the device Code List.
Switch the relevant device on manually.
Briefly press the required souce key(
Keep the key pressed for approx. 3 seconds until the blue LED remains solid.
CODE
Point the remote control at the device and briefly press the button
If the device has no program function, press
The remote control starts the code search after 6 seconds and transmits all codes consecutively at 1-
second intervals (see also next section). The LED will lights up for each transmission.
As soon as the device responds to the remote control, press
the right time, you can return to the code to which the device responded step by step by pressing
key.
NOTICE!
The correct code will not be stored and the code search will have to be repeated, if you have
ended the code search with
device.
To cancel the search, press
Code searching by brand name
This function gives you the option of searching by brand name (see code list). This is done as follows:
Switch the relevant device on manually.
Briefly press the required source key (
Keep the key pressed down for approx. 3 seconds until the blue LED briefly flashes and then
CODE
remains on.
Enter the one-digit code according to the following table:
Key 1 = Medion, Tchibo
Key 2 = Philips, Radiola, Philco, Erres, Pye
Key 3 = Sony, Akai, Panasonic, JVC, Sharp, Toshiba, Daewo
Key 4 = Thomson, Brandt, Fergusson
Key 5 = Saba, Nordmende, Telefunken
Key 6 = Grundig, Blaupunkt
Key 0 = all brands.
Continue pressing the
cordingly. Proceed quickly, otherwise the automatic code search will start.
Save the code by pressing
If all the codes have been searched, the blue LED will flash for approx. 3 seconds.
38
,
TV STB
, or
P+
to save the code.
,
TV STB
ENTER
.
EXIT
,
TV STB
key (or for video recorders
P+
.
ENTER
, , ).
VCR AUX
or (VCR only) until the device that is to be controlled
P–
, , ).
VCR AUX
( ) or instead.
PLAY
ENTER
at an earlier or later time, without any reaction by the
, , ).
VCR AUX
or
PLAY
once.
P+
. – If you did not press
), until the device responds ac-
at
ENTER
P–