Propeller B
Fig. 25
Propeller A
• Use the supplied screwdriver and gently loosen the screw in clockwise direction for propeller A and in
counterclockwise direction for propeller B.
• Then remove the propellers from the motor shaft.
• Match the "D" shape on propellers to the flat side of the indicated "D" gap on motor shafts when assembling the
new propellers. See Fig. 26.
• Gently tighten the screw in counterclockwise direction for propeller A and in clockwise direction for propeller B.
Loosen the screw
Clockwise
Counterclockwise
Fig. 26
Make sure the propellers are in the correct position, otherwise the drone will not fly properly.
52
Front
Tighten the screw
Counterclockwise
Clockwise
Propeller A
Propeller B
"D" Gap
A=A
B=B