Flight Preparation; A) Flight Battery Charging - Reely X-190 RTF Bedienungsanleitung

9. Flight preparation

a) Flight battery charging

• Remove the flight battery from the quadrocopter
before charging.
• A suitable USB mains unit or USB cigarette lighter
adapter (neither enclosed) may be used for power
supply to the enclosed USB charging cable (E). The
output current must be at least 500 mA.
• Alternatively, the USB port of a computer or USB hub
with a dedicated mains unit that can supply a current
of 500 mA per port can be used.
• Connect the USB charging cable from the delivery to the USB power supply with its USB plug (as shown above in
Fig. 1, e.g. a USB mains unit or computer USB port). Then connect the small plug of the USB charging cable to the
corresponding socket of the flight battery. Observe proper alignment of the plug (the plug contour must match the
socket of the charging cable).
• If the battery is not defective and power supply is warranted, charging commences. This is signalled by the flashing
red LED in the USB charger. Charging will take approx. 130 minutes until battery is fully charged.
• The following LED indications are possible:
- LED is flashing: The battery is being charged
- LED is constantly on: The battery is full or fully charged
• To install the flight battery place it into the battery
compartment as shown in Fig. 2.
• Notice the right terminals. Lay the wires into the slots
at both sides of the battery compartment.
• Use the hook and loop tape to tighten the battery.
• Observe proper alignment of the plug (the plug
contour of the flight battery must match the socket of
the quadrocopter cable).
• To indicate low battery power during flight the two LEDs at the rear will flash. Return the quadrocopter
immediately to the ground and recharge the flight battery after a 10 minute cooling-off period.
40
Fig. 2
Fig. 1