Neoss NeoScan 200 Gebrauchsanweisung Seite 21

21
CAUTION: Scanner Tips are shipped non-sterile. You must sterilize them before the first use.
CAUTION: Avoid any liquid from leaking into the air outlet near the Scanner Tip mount or the
air inlet at the rear of the Handpiece, otherwise the Handpiece may be damaged.
To prepare the scanner, follow these steps:
•
Make sure the Lens Window at the base of the scanner is clean by wiping it with a moist,
lint-free cloth or lens tissue.
•
Slide the Scanner Tip onto the scanner as shown below.
Starting Scanning
To start scanning, place the Scanner Tip on the surface of the tooth to stabilize the scanner
and press the Scan button. Wait until a 3D model appears on the 3D model display screen, and
then slowly move it along the arch at 0-5mm from the teeth.
Getting Started