Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Regulatory Information
the EMC information provided in this documentation.
Other equipment can interfere with communications with the device, even if the equipment
complies with CISPR emissions requirements.
WARNING: Portable and mobile RF communications equipment (including
peripherals such as antenna cables and external antennas) should be used no closer than
30 cm (12 inches) to any part of the DEVICE, including cables specified by the manufacturer.
Otherwise, degradation of the performance of this equipment could happen.
WiFi
The device operates with the 802.11a/n/ac protocol. Channel 38 or 46 is priority used for the
handpiece. The channel bandwidth is 40MHz. The frequency range is 5150-5250MHz,5725-
5850MHz (the actual frequencies are dependent on local regulations and the configuration of
the product). The maximum output power is 17.88 dBm.
This device complies with part 15 of the FCC Rules and contains license exempt transmitter(s)/
receiver(s) that comply with ISED's license-exempt RSS(s).
Operation is subject to the following two conditions:
•
This device may not cause interference.
•
This device must accept any interference, including interference that may cause undesired
operation of the device.
NOTE: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
SAR Value for Handpiece:
0.798 W/Kg,10g for CE
0.011 W/Kg,1g for FCC
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Limited by local law regulations, the version for North America does not have a region
selection option.
The device is for indoor use only and operates in the 5150-5250 MHz band to reduce the
potential for harmful interference to co-channel mobile satellite systems.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures: —Reorient or relocate the receiving antenna.
34
Werbung
