Neoss NeoScan 200 Gebrauchsanweisung Seite 31

31
The scanner does
not cast light, and a
static preview image is
displayed in the video
preview screen.
Scanner is not shown
in the 'Scanner List' in
the software while
the Status Indicator
keeps blinking in
breathing mode
Close the software, and then launch the software again.
Reset the network in the scanner. To do so, while the Status
Indicator is in breathing mode, simultaneously press the Scan
Button on both sides for two seconds and release. The Status
Indictor should start blinking rapidly, then enter breathing
mode. The device should then be shown in the 'Scanner List' in
the software.
Troubleshooting