RADEMACHER RolloTube I-line Sun Medium Serie Original - Betriebs- Und Montageanleitung Seite 44

Configuring tubular motors
The tubular motors can be individually configured with the help of a cord circuit setting
unit (20).
The following configurations are possible.
◆ Reload the factory settings.
◆ Fabric tensioning (reversing) after the end point has been reached or switching
on/off after obstacle detection
Loading factory settings during the commissioning process
Automatic configuration of the upper end point is available again once the factory settings
have been loaded.
NOTE
We recommend undertaking these settings with two persons.
IMPORTANT
The tubular motor may not be in operation.
1.
1.
2.
Fabric tensioning (reversing) after the end point has been reached or
switching on / off after obstacle detection
1.
1. 2.
+
SET
2.
10 s
44
First press the set button (7) on the tubular motor (9) and subsequently press the SET button on the cord circuit
+ 2.
10 s
setting device (20) (possibly a second person carries this out). Press and hold both buttons for approx. 10 seconds.
SET
Additionally switch on the tubular motor (▲/▼). Hold all buttons.
After approx. 10 seconds the tubular motor acknowledges loading of the factory settings by briefly running up and
10 s
down. Subsequently release all buttons and switch off the power to the tubular motor briefly.
First press and hold the SET button on the cord circuit setting device (20) and subsequently press and hold the up
or down button for 10 seconds.
10 s
After 10 seconds the reversing function will be switched on or off.
Factory setting = reversing is switched on.
After approx. 10 seconds the tubular motor acknowledges switching on / off of the reversing function by briefly
starting up.
NOTE
Additional settings can be undertaken with the optionally available RT ConfigTool. Please
refer to the information on our Website www.rademacher.de.
Factory settings:
End points:
Fabric tensioning (reversing) after the
end point has been reached or switching
on / off after obstacle detection:
EN
No end points stored
activated