RADEMACHER RolloTube I-line Sun Medium Serie Original - Betriebs- Und Montageanleitung Seite 32

Important assembly instructions
Incorrect assembly of the awning may lead to an increased risk of injury.
For this reason, arrange to have all installation and repair work carried
out by a specialist firm.
Check:... :
◆ ... that the awning is suitable for installation of the tubular motor.
◆ ... that the tubular motor is a suitable size.
◆ ... that the structural base is sufficiently stable for the operation of an electrically
powered awning.
IMPORTANT
◆ Check that the voltage / frequency on the type plate corresponds to local mains
conditions prior to installation.
◆ All cables and equipment not required for operation of the equipment is to be removed
or deactivated prior to installation of the tubular motor.
◆ Moving drive parts to be operated at a height under 2.5 m from the floor must be
protected.
◆ If the tubular motor is to be controlled with a switch with a default OFF setting, then
the switch is to be positioned in the line of sight of the tubular motor and at a height
of at least 1.5 m.
◆ The set button (7) for the tubular motor must be easily accessible and the motor
cable (13) must be laid without kinking.
For automatically actuated awnings:
◆ A minimum gap of 0.4 m to other parts in the area must be maintained when the
awning is fully extended.
◆ Awnings used in an awning system must maintain a minimum height of 1.8 m.
Preparing the awning system
Risk of injury due to joint arms falling down (19). The joint arms (19)
are under high spring tension and may fall down suddenly when the
STOP
awning drive is released.
◆ Retract the awning fully and secure the joint arms (19) with two ratchet straps prior
to mounting the tubular motor in order to avoid sudden dropping.
NOTE
The preparation measures must be adapted to the existing awning system on site, due
to the various models of awning available. The following describes the most important
general steps for preparing the awning system for the installation of the RolloTube I-line
Sun tubular motor.
Mounting / dismounting the adapter (Fig. 2 ) *
* = The adapter is supplied pre-installed by the factory.
1. Mounting the adapter (8)
Slide the adapter (8) over the Magnetic ring (14) on the drive head
until it engages. In doing so, check the correct positioning of the groove
in the adapter (8).
32
There is a risk of short-circuits and fire in the event of direct weather
influences to the unprotected tubular motor.
The mounted tubular motor may never be subjected to direct rain or
snow, as this may lead to life-threatening situations due to short-circuits
and damage to the motor.
◆ Only install the tubular motor in awning systems where the motor is structurally
protected from the direct influences of rain and snow.
◆ Install a suitable protective hood for the tubular motor, if necessary.
Risk of injury when working at heights due to falling.
◆ Take suitable measures to ensure safe working at heights.
◆ Ensure that ladders and scaffolding stand securely.
STOP
Mortal danger in the event of operation without configured end points.
◆ The end points must be configured in order to ensure safe operation. In order to do so,
please refer to the corresponding chapter in this manual provided on page 41.
1. Fully retract the awning.
2. Secure the joint arms (19) with ratchet straps in order to avoid
sudden dropping.
3. Remove the awning gear mechanism.
2. Dismantling the adapter (8)
Press the two retaining springs on the Magnetic ring (14) downwards
and pull the adapter (8) off of the Magnetic ring (14).
EN
Never drill or insert screws in the area
of the drive. Doing so may damage the
tubular motor.